Deck tread


This topic contains 0 replies, has 1 voice, and was last updated by  Myk Ryan September 9, 2017 at 10:37 pm. This post has been viewed 167 times

Viewing 1 post (of 3 total)
  • Author
  • #138343

    Myk Ryan

    Hi again,

    Having a bit of trouble with kiwi grip deck paint.

    I prepped the deck on our 40 ft carved planked launch about 18 months ago,checked caulking and undercoated, followed by 2 coats of kiwi grip on the cabin tops and 3 on the fore, side decks, cockpit and duckboard.

    Cabin tops have been fine but the fore and side decks are showing every line in the deck planks as grubby from what I guess is road dust from the nearby bridge. I’m thinking of taking it back to the undercoat again and replacing it with a stick/ glue on non skid material,  thereby covering the deck and sealing them a little better. I understand that the deck is going to move a little over time but it’s got to look better than what’s on there now. Figure I can always reglue if required around the edges. Thinking of one of the harder products as I think the closed cell foam stuff mite get filthy anyway.

    Anyone had any experience with any of these products on this sort of deck?

    Would appreciate any advice from those with any similar experience.

    Thanks  😎


Viewing 1 post (of 3 total)

You must be logged in to reply to this topic.

Posted in